Vista Ademco N7227V5 Manuel D’Utilisation

• One Master code for entire system (User 2). Installer code is User 1.

• 4 secondary user codes (Users 3–6).

• One duress code (User 8).

Duress Code: An emergency code that, when used to disarm or arm the system, will send a
silent duress message to the central station.

•

 

Up to 3 programmable panic key functions are provided.

•

 

Designated as Zones 7, 95, 96.

•

 

Activated by wired and wireless keypads.

•

 

Reported separately.

If the paging feature has been programmed for your system, your pager will respond to
certain conditions as they occur in your system, and display code numbers indicating the type
of condition that has occurred.

“Quick Arm” may be programmed, allowing use of the [#] key in place of the security code for
arming (Quick Arm will not work unless the Master code has been programmed into the
system).

This is a hardware-enabled option, achieved by cutting a red jumper on the PC board. If the
“Alarm Output” loop connected to an external sounder is then opened or shorted, a “bell
trouble” message will be displayed at the touchpads, accompanied by a trouble sound. A
trouble report will also be sent to the central station.

If RF jam detection is programmed for a 5800 RF system, the RF receiver will detect a
condition that may impede proper RF reception (i.e., jamming or other RF interference). Such
a condition will produce a message display, and a report will be sent to the central
monitoring station (if trouble reporting is enabled).

Optional Output Relays

•

 

Up to 4 relays using one 4204 Relay Module.

•

 

Actions programmable to respond to zone activity or manual keypad entries.

Optional VIP Module

•

 

Supports the ADEMCO 4285/4286 VIP Module.

•

 

Provides access to the system via on-premises or off-premises phones for arming,
disarming, etc., plus control of relay outputs.

Allows all messages that have been programmed to go to the primary telephone number to be
reported additionally to a 7720 PLUS or 7820 radio.