Viking Huskylock 936 Manuel D’Utilisation

—66—

D

C

B

A

(Included in optional Huskylock 936 Cover 

Stitch Kit, Part number: 412 6716-01)

1. Press the stitch selection button until “Auto 

M” “Cover stitch wide” appears. (Illus. A)

2. Press the fabric selection button until appro-

priate fabric type appears.

    Note: Use needle A & E.

3. Raise the presser foot and snap on Bias Tape 

Binding foot.

4. Trim off the two top corners. (Illus. B) 

    Note: 1”-11/4” (25-28 mm) width tape can be 

used.

5. Insert the tape into tape guide. Use tweezers 

to feed the tape through slot on front of foot.

6. Extend tail of bias tape 2” (5 cm) behind foot. 

(Illus. C)

7. Lower presser foot and sew bias tape only to 

test stitch.

8. Raise presser foot and insert fabric from the 

left side of tape guide until edge of fabric lays 

against pressed edge of bias tape. (Illus. D)

9. Lower presser foot and sew bias tape along 

edge of fabric.

    Hint: Hold tail of bias tape at back of foot to 

guide until fabric is under needles.

Cut

Tape Guide

Bias Tape
Binding Foot

5cm