Vertek/XTC Camcorder XTC280 Manuel D’Utilisation

4

midlandusa.com

1. To insert the battery, push down the battery door latch on the right side 

of the camera.  Door will release.  Push forward to remove.

2. Install Lithium-Ion battery.

3. Return battery door and click into place.

Solid Green

Indicates full battery life

Blinking Green

Battery is charging

Solid Red

Indicates half battery life

Blinking Red*

Indicates low battery life

No Light

Battery is dead

*Note: When the red battery LED begins blinking, be prepared 

to charge the battery because the camera will stop recording 

at this point.

1. Open and fold down the back rubber cover.
2. Insert Micro SD card into slot observing proper direction (shown below).

3. Return rubber flap into place.

1. Move the RECORD switch forward.  This turns the camera on.

2. The battery indicator will light from red to green.  The Micro SD card 

indicator will light green.  The record indictor will begin flashing red after 

8 seconds.  This indicates the camera is capturing video.

3. To stop recording, move the RECORD switch back to the off position.

Note: The camera will continue recording for 3 seconds after toggling 

the switch to the off position.

Green

 1 GB or more available.

Orange

512 MB to 1 GB available.

Red

Below 512 MB

 available or 

no Micro SD card installed.

Flashing Red

Cannot read the card.

Flashing Green

Indicates card has been 

reformatted.

*Note: Requires Class 4 or higher Micro SD card

512 MB

6.5 Minutes

5.5 Minutes

1 GB

13 Minutes

11 Minutes

2 GB

26 Minutes

22 Minutes

4 GB

52 Minutes

44 Minutes

8 GB

104 Minutes

88 Minutes

16 GB

208 Minutes

176 Minutes

32 GB

416 Minutes

352 Minutes

*Note: The camera automatically splits the video into 2 GB 

segments.

The XTC280 uses Digital Image Stabilization (DIS) to visually stabilize 

the video from a shaking or vibrating camera.