Valor Auto Companion Inc. MILES INDUSTRIES 1210DKA Manuel D’Utilisation

4001303-01

31-3/4”

35-3/4”

Overview

1200 Heater

Backing Plate

Wall Finish

Alhambra Doors

1210DKA Alhambra

Door Kit

(incl. magnet bracket)

Magnet

Bracket

1210DKA Alhambra Door Kit

The 1210DKA Alhambra Door Kit may be fitted to the Valor model 1200 heater, either at the time the heater is installed

or retrofitted afterwards (provided existing wall and hearth finish allow—see Note above). Installation of the Alhambra

doors affect mantle clearances, framing dimensions, or other specifications listed in the heater installation manual—see

installation manual packed with the heater.

The 1210DKA Alhambra Doors may also be installed with optional

614CVI, 615CVI Cast Surrounds, 616STK, 617STK Stone Trim Kits (see installation instructions with each kit).

NOTE: The bottom of the plate is flush

with the bottom of the heater. Bottom

of the heater MUST be flush with or

higher than the finished hearth.

NOTE: To install the kit’s backing plate, the surface of the finished hearth or floor must be at

the same level as the bottom of the heater. Please be aware that the backing plate mounting

can ONLY accommodate 1/2” wall thickness.

Note: This kit must be installed or serviced by a qualified installer, service agency or gas supplier.

These instructions are to be used in conjunction with the main installation instructions for the 1200.

CSA approved for use with

Valor Model 1200 Heater ONLY

INSTALLATION INSTRUCTIONS

Mantel or Shelf Clearances

For Mantel of Shelf Clearances, see the Installation manual provided with the 1200DV Ventana engine.