Unisys EFP9800 Series Manuel D’Utilisation
Diagnostics and Print Tests
3–24
3255
4073–002
3. Set the DIP switches to the following settings:
Switch
1
Switch
2
Switch
3
Switch
4
Switch
5
Switch
6
Switch
7
Switch
8
ON OFF ON OFF OFF OFF OFF OFF E13B
Font
Test
Test
ON OFF ON OFF OFF OFF OFF ON CMC7
Font
Test
Test
4. Turn the printer back on to begin the test.
The green Slip In LED blinks, indicating that the printer is ready for the
check to be inserted.
check to be inserted.
5. Insert the check into the printer from the front, face up, with the MICR
characters to the right.
See
“Verifying Checks” in “Section 2: Operating the Printer” for more
information about inserting checks to be read by the MICR check reader.
Note: Do not hold or keep the check from moving during the MICR check
reader transaction or the check numbers will not be read accurately.
6. Slide the check toward the back of the printer along the right side until it
covers both sensors.
The green Slip In LED turns on continuously when both sensors are
covered, indicating that the check is inserted properly. The printer reads
the magnetic characters on the check and feeds the check back out.
covered, indicating that the check is inserted properly. The printer reads
the magnetic characters on the check and feeds the check back out.
The printer prints the decoded data on the receipt, and then prepares the
printer to receive another check to continue the test.
printer to receive another check to continue the test.
7. To stop the test, wait until the printer completes a cycle and is waiting until
a new check is inserted.
8. Turn the printer off and reset the DIP switches to what they were when you
started.
For normal operation settings, see “Switch Settings” in section 5.
9. Turn the printer back on.