Ultimate Technology 600 POS Manuel D’Utilisation

  

Series 600 POS Keyboard 

 

 

 

 

  

MSR PROGRAMMING FOR UTC OPOS DRIVERS 
 
The MSR is programmed by using a special prefix.  This prefix allows the OPOS driver to 
determine where the data is coming from.  An example of the data stream is shown below.  If a 
track is missing from the magnetic stripe card, the prefix and suffix for that track will still be sent. 
 
MSR Track 1 
14/F0/14/F0/14c10……..data……..? 
 
MSR Track 2 
c20……….data…..……..?<CR> 
 

Table 8 MSR Programming for UTC OPOS Drivers 

Function Code (s) 

Operation 

1.  Swipe Program Card.  While in programming mode, at the Series 600 Keyboard, enter 

Function Code 10 (prefix). 

2.  At the Series 600 Keyboard numeric keypad, enter sub-function 8 (add 

CTL/BREAK/CTL/BREAK/ALT). 

3.  At the auxiliary keyboard, type c10. 
4.  At the Series 600 Keyboard, press ENTER. 
 

1.  Swipe program Card.  While in programming mode, at the Series 600 Keyboard, enter 

Function Code 12 (suffix). 

2.  At the auxiliary keyboard, type ?. 
3.  At the Series 600 Keyboard, press ENTER. 
 

1.  Swipe Program Card.  While in programming mode, at the Series 600 Keyboard, enter 

Function Code 17 (bad read). 

2.  At the Series 600 Keyboard numeric keypad, enter sub-function 8 (add 

ALT/BREAK/ALT/BREAK/ALT). 

3.  At the auxiliary keyboard, type c11? 
4.  At the Series 600 Keyboard, press ENTER. 
 

1.  Swipe Program Card.  While in programming mode, at the Series 600 Keyboard, enter 

Function Code 14 (prefix). 

2.  At the auxiliary keyboard, type 20. 
3.  At the Series 600 keyboard, press ENTER.