Sterling Welder 882.01749.00 Manuel D’Utilisation

882.01749.00  

71 

of 

93 

 

 

1.   Switch the control unit “Off” with 

the “On/Off” switch. 

2.  Disconnect the power supply. 

3.  Open the toggle latches on the 

dosing motor. 

4.   Remove the dosing unit from   

            the dosing motor. 

5.  Empty the dosing module. 

6.  Open the profile clamp on the 

dosing hopper. 

7.  Remove the dosing hopper from the dosing module. 

8.  Dismantle the dosing module and remove the shear (D) as described above in 5.2. 

9.  Loosen and remove the two M6 x 30 socket screws (C) on top of the dosing disc (A). 

10. Remove the center M6 x 12 socket screw (B) and replace with an M6 x 30 or 60 screw. 

11. Lift the dosing disc (A) from the 

dosing unit housing (B) by 

tightening this screw. 

12. Clean the shear plate with a 

cotton cloth. 

13. Clean the dosing hopper and the 

dosing disc in soapy water. 

14. The dosing unit housing may also 

be cleaned with a soft cloth, 

keeping liquids out of the 

bearings.