SnapGear 1.7.8 Manuel D’Utilisation
Select Internet connection
The next step is to select the method for connecting your SnapGear appliance to the
Internet. From the SnapGear appliance Config Pages, in the Networking menu, select
Connect to Internet and select the method to connect to your local ISP. You can
connect using a cable, ISDN, DSL or analog modem connection. Select the connection
type and click Continue.
Internet. From the SnapGear appliance Config Pages, in the Networking menu, select
Connect to Internet and select the method to connect to your local ISP. You can
connect using a cable, ISDN, DSL or analog modem connection. Select the connection
type and click Continue.
Connect to Internet – cable modem
If you are connecting to the Internet using a cable modem, select a cable connection,
select your cable ISP from the list and click Next. If your provider does not appear, select
Generic Cable Modem Provider. For cable modem providers other than Generic, enter
your username and password and click Finish. You are now ready to connect. Click the
Reboot button to save your configuration and reboot your SnapGear appliance.
select your cable ISP from the list and click Next. If your provider does not appear, select
Generic Cable Modem Provider. For cable modem providers other than Generic, enter
your username and password and click Finish. You are now ready to connect. Click the
Reboot button to save your configuration and reboot your SnapGear appliance.
Connect to Internet – ADSL
If you are connecting to the Internet using ADSL, you must select the connection method
PPPoE, DHCP, or Manually Assign Settings. Alternatively, the SnapGear appliance
can determine the connection method automatically.
PPPoE, DHCP, or Manually Assign Settings. Alternatively, the SnapGear appliance
can determine the connection method automatically.
Use PPPoE if your ISP uses username and password authentication to access the
Internet. Use DHCP if your ISP does not require a username and password, or if your
ISP instructed you to obtain an IP address dynamically. If your ISP has given you an IP
address, you must manually assign the settings on the SnapGear appliance’s Internet
interface. Select the appropriate method and click Apply.
Internet. Use DHCP if your ISP does not require a username and password, or if your
ISP instructed you to obtain an IP address dynamically. If your ISP has given you an IP
address, you must manually assign the settings on the SnapGear appliance’s Internet
interface. Select the appropriate method and click Apply.
For PPPoE, enter the username and password for your ISP account. By default, your
SnapGear appliance maintains the ADSL connection continuously; however you can
change this if required to Connect on Demand. For on demand connections, enter an
Idle Disconnect Time. This is the time (in minutes) that the SnapGear appliance will wait
before disconnecting if the line is idle.
SnapGear appliance maintains the ADSL connection continuously; however you can
change this if required to Connect on Demand. For on demand connections, enter an
Idle Disconnect Time. This is the time (in minutes) that the SnapGear appliance will wait
before disconnecting if the line is idle.
DHCP connections also require a host name for your SnapGear appliance. Select
Manually Assign Settings and enter the IP Address and Netmask and optionally the
Gateway and the DNS Address if provided by your ISP. Reboot the SnapGear appliance
for the new configuration to take effect.
Manually Assign Settings and enter the IP Address and Netmask and optionally the
Gateway and the DNS Address if provided by your ISP. Reboot the SnapGear appliance
for the new configuration to take effect.
If you are unsure of the ADSL Connection Method, select Autodetect connection type
and your SnapGear appliance will attempt to automatically determine the connection
method.
and your SnapGear appliance will attempt to automatically determine the connection
method.
Connecting to the Internet
31