Simrad SIMRAD HS50 Manuel D’Utilisation

Page de 63
INSTALLATION 
20221081 / F 
13
 
Pedestal mounting (option) 
An optional mounting pedestal (part no. 20213021) can be 
delivered from Simrad by request. This pedestal is designed for 
2-inch mast mounting. 
Attach the pedestal to the Sensor unit with the four screws and 
washers similar to the bracket mounting option described on 
page 12. 
 
self-bonding tape
Connector with
Cable duct
Cable ties
Pipe clamps
 
Lift the Sensor unit in the preferred direction 
on the mast. Use two pipe clamps with 
preferred size for mounting the Sensor unit 
pedestal to the mast top. 
Ensure that the Sensor unit is mounted in 
such a way that torsion movement relative to 
the mast is kept at an absolute minimum. 
All nuts should be secured with washers or by 
self-locking nuts. 
Connect the cable from the Processing unit to the cable as 
described in page 11. 
Cable wiring 
The wiring for the Sensor unit cable in the Processing unit 
terminals is as follows: 
Cable Wire No. 
Signal Description 
Processing Unit 
Connector P201 
  
Label 
Screen Cable 
shield  GND 
4 Transmit 
COMM+ 
3 Receive 
COMM- 
2 +24 
VDC 
PWR+ 
1 Power 
ground 
PWR-