Siemens Welding System ST PCS 7 Manuel D’Utilisation
Process I/O
Dezentrale Peripherie ET 200pro
Introduction
11/57
Siemens ST PCS 7 · November 2007
11
Module support
Various module supports are available for mounting the
ET 200pro:
• Narrow module support
• Narrow module support
The narrow module support permits complete preassembly
on a workbench as a result of two mounting flanges outside
the ET 200pro station.
• Compact-narrow module support
The compact-narrow module support permits the most space-
saving design.
Expansion limits
• Number of electronics modules per station (between interface
module and terminating module): up to 16
• Max. width (without module support): 1 m
• Electronics/sensor supply 1L+ max. 5 A per ET 200pro station
• Load voltage supply 2L+ max. 10 A per potential group
• Maximum address range of an ET 200pro station: 244 bytes
• Electronics/sensor supply 1L+ max. 5 A per ET 200pro station
• Load voltage supply 2L+ max. 10 A per potential group
• Maximum address range of an ET 200pro station: 244 bytes
for inputs and 244 bytes for outputs
ET 200pro configuration
The SIMATIC ET 200 configurator can be used to compile an
ET 200pro station rapidly and simply. It knows the configuration
rules, and supports selection of all components and associated
accessories in interactive mode. The SIMATIC ET 200 is avail-
able in the current CD-ROM Catalog CA 01 and on the Internet.
Additional information is available in the Internet under:
Additional information is available in the Internet under:
http://www.siemens.com/et200
■
The distributed ET 200pro system is connected to SIMATIC
PCS 7 automation systems (controllers) over PROFIBUS DP.
Data transfer rates of up to 12 Mbit/s are possible.
The ET 200pro is integrated into SIMATIC PCS 7 using standard
The ET 200pro is integrated into SIMATIC PCS 7 using standard
driver blocks. You can therefore configure and parameterize the
ET 200pro in the SIMATIC Manager of the engineering system
extremely simply using HW-Config.
© Siemens AG 2007