Siemens TV Converter Box G120 Manuel D’Utilisation

 

 

 

 

 

 

 

    

 

 

 

 

T I A  Training Document

 

Page 52 of 147 

 Module  

 

     H01 

Issued: 02/2008 

  Frequency Converter SINAMICS G120 on PROFIBUS DP and PROFINET 

Preface         Notes         Startup with PROFIBUS         Startup with PROFINET         Program Example 

 

Startup with the Software STARTER using the Connection Kit 
 
Below, the startup of the frequency converter SINAMICS G120 with the software STARTER is 

described. The PC on which the software STARTER is running has to be connected to the 

SINAMICS G120 by means of the Connection Kit and a serial interface. 

 
After the parameter assignment was successful, the converter can be controlled with the Basic 
Operator Panel (BOP). 
 

 

 
The buttons are assigned as follows: 

 Start motor 

 Stop motor 

 Reversal 

 Take motor to the inching mode 

 Increase speed 

 Decrease speed 

 
To assign the parameters for the SINAMICS G120,  perform the following steps: 

1.  The parameter assignment tool for the SINAMICS G120 is the ’STARTER’ that is called here 

with a double click. (

→ STARTER)