Sennheiser SR350 IEM Manuel D’Utilisation

18

Connecting the headphones



For monitoring purposes, connect the supplied earphones or any
Sennheiser stereo headphones with 3.5 mm stereo jack plug to the
headphone output (PHONES)



. 



First, set the volume control



 

to the lowest volume by turning it to the

left as far as possible. Then gradually turn up the volume.

Using the components

Switching the components on/off

Switching the transmitter on/off



Press the 

ON 

button

 

 to switch the transmitter on.



To switch the transmitter off, press the 

ON 

button until “OFF” appears on

the display.

Note:

The transmitter can only be switched off when the standard display is
shown on the display panel. Within the operating menu, the 

ON

 button

serves as the ESC (cancel) key, i.e. you cancel your entry and return to the
standard display.

After switch-off, the transmitter is in standby mode. To disconnect the
transmitter from the mains, pull out the mains connector from the wall
socket!

Switching the receiver on/off



To switch the receiver on, turn the volume control



 clockwise until it

clicks. The red LED



 lights up.



To switch the receiver off, turn the volume control



 counterclockwise

until it clicks. The red LED

 

goes off.

Note:

y The receiver has a short switch-on delay.
y Remove the batteries or the accupack when the receiver will not be used

for extended periods of time.

CAUTION!

Danger of hearing damage!

Listening at high volume levels for long periods can lead to
permanent hearing defects.



Set the volume for the connected headphones to the
minimum before putting the headphones on.











ew300_350_IEM_INT.book  Seite 18  Freitag, 7. März 2008  8:55 08