Russound ST2S Manuel D’Utilisation

24

NOTE: To control the ST2 Tuner through the
UNO-S2 keypad, the tuner must be configured
as a source using the CAV6.6 programming
steps. 

The tuner is power managed by the CAV6.6 or other
RNET-enabled controller. If the tuner is in standby
mode, any button press of the UNO-S2 keypad will
bring the tuner out of standby mode.    

On the UNO-S2 keypad, press 

to select

either Tuner 1 (SIRIUS) or Tuner 2 (AM/FM) by

choosing the tuner’s preassigned source num-

ber.

Push 

to toggle between AM band and FM

band reception.

Push 

to toggle between SIRIUS modes. 

Press and release 

until EXIT is displayed to

exit SIRIUS mode selection menu.

Use

and 

for manual tuning or channel

selection. The frequency or channel will appear

on the keypad and the active tuner. To move

quickly through the channels, press and hold

either 

or 

for more than 1.5 seconds

.

A press on

will seek the next higher tune-

able station. If a tuneable station is not found,

end the SEEK function by pressing

again.

To scan, press and hold then release 

. The

tuner scans through tuned stations with a 5-sec-

ond preview before moving to the next station.

To end scanning, press

again.

To check SIRIUS signal strength, press and hold

then release. The display shows the signal

strength rating. To exit, press 

again.

To select a bank, press and hold 

for bank

up or 

for bank down. The bank’s name will

be temporarily displayed on the UNO-S2.  

Press

and 

to scroll through the memo-

ry presets for the selected bank. This procedure

will step through all of the presets in the current

bank, then loop back to start at the first one.

Only configured presets will be displayed.

Press 

to mute/unmute the tuner audio output.