Rocketfish RF-TVMLPT01 Fascicule

• Stud finder

• Awl

• Level

• Pencil

A TV bracket (1)

B Wall plate (1)

C M4 x 12 mm screws (4)

D M4 x 30 mm screws (4)

E M4 washers (4)

F M4 spacers (4)

G Locking screw (1)

H 5/32 in. hex key (1)

I 5/16 in. x 2¾ in. lag bolts (2)

J Concrete anchors (2)

Thank you for choosing the 

Rocketfish RF-TVMLPT01.

The RF-TVMLPT01 TV mount 

is designed to support

a TV weighing up to 

50 lbs. (22.7 kg).

• Hammer (Concrete Only)

• Tape measure

• Power drill

• 3/16 in. wood drill bit

• 3/8 in. masonry 

  drill bit(Concrete Only)

• Socket wrench with ½ in. socket    

  or adjustable wrench

• Phillips screwdriver 

M4 x 12mm

 in.

M4 bag

Miscellaneous bag

Lag bolt bag

      Install the TV bracket locking screw (G) into the TV bracket (A) using the hex key (H). 

      Do not screw in more than three or four turns.

Align the TV bracket (A) with the mounting screw holes 

on the back of the TV. Place the washers (E) over 

the screw holes on the TV bracket. 

Note: If the hole pattern on your TV is 75 mm x 75 mm, 

do not use the washers. Insert the screws (C) though 

the screw holes and tighten. 

M4 x 30mm

M4 

M4 

Attach the TV bracket [A] to the back of the TV using the washers (E), the spacers (F), and the screws (D).

Note: If the hole pattern on your TV is 75mm x 75mm the washers(E) will not be used.