Ridgid Digital Inspection Camera microEXPLORER Manuel D’Utilisation

5

1. This device may not cause harmful inter-

ference.

2. This device must accept any interference

received, including interference that may
cause undesired operation.

NOTE! This equipment has been tested and

found to comply with the limits for
Class B digital devices, pursuant to
Part 15 of the FCC rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This equip-
ment generates uses and can radiate
radio frequency energy and, if not in-
stalled and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that in-
terference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio or
television reception, which can be de-
termined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:

• Reorient or relocate the receiving an-

tenna.

• Increase the separation between the

equipment and receiver.

• Consult the dealer or an experienced

radio/TV technician for help.

Use of shielded cable is required to comply
with Class B limits in Subpart B of Part 15 of
the FCC rules.

Do not make any changes or modifications to
the equipment unless otherwise specified in
the manual. If such changes or modifications
should be made, you could be required to
stop operation of the equipment.

NOTE! Battery delivered with partial charge. It

is recommended that the battery be
fully charged before use. 

See Battery

and Charger section.

NOTE! Be sure to read 

Battery Precautions

section

.

1. With dry hands, place thumb on lock

button and slide toward middle to re-
lease battery cap.

(Figure 2).

2. Lift and pull to remove cap when re-

leased. 

(Figure 3)