Rangemaster 90 CERAMIC U109650-02 Manuel D’Utilisation

This appliance must be installed by a qualified electrician 
to comply with the relevant regulations and also the local 
electricity supply company requirements.

The cooker must be connected to the correct electrical 
supply as stated on the voltage label on the cooker, through 
a suitable cooker control unit incorporating a double pole 
switch having a contact separation of at least 3mm in all 
poles. This cooker must not be connected to an ordinary 
domestic power point.
The total electrical load of the appliance is approximately 
15 kW. The cable size used should be suitable for this load 
and comply with all local requirements.
Access to the mains terminal is gained by removing the 
electrical terminal cover box on the back panel.

Connect the mains cable to the correct terminals for your 
electrical supply type. Please note the maximum cable size 
is 10mm2 for the 3-pronged links.

Secure the mains cable 
using the cable clamp.

Where the installation is protected by a 30 milliamp 
sensitivity residual current device (RCD), the combined 
use of your cooker and other domestic appliances may 
occasionally cause nuisance tripping. In these instances the 
cooker circuit may need to be protected by fitting 100mA 
device. This work should be carried out by a qualified 
electrician.

Loosen the 3 screws along the front bottom edge of the 
cooker. Hook the central keyhole over the central screw. 
Twist and fit each end keyhole over their respective screws. 
Tighten the fixing screws.

Press the oven light switch and check that the light is 
working.
NB. The oven light bulb is not included in the guarantee.

Turn on each plate in turn and check that it heats up.

Open the grill compartment door. Turn on the grill control 
and check that the grill heats up.

Set the clock to the time of day 
When the clock is first connected the display will flash 

(

) and (

) alternately.

To set the clock to read the time of day turn and hold the 
Timer knob to the clock symbol 

 and at the same time 

turn the Adjusting knob left or right until the clock shows 
the time of day. Remember this is a 24 hour clock. Let go of 
the Timer knob and it will spring back to the vertical oven 
manual setting.
Turn on the oven and check that the oven fan starts to turn 
and that the oven starts to heat up. Turn off the oven.

Please complete your details in this Guide, inform the user 
how to operate the cooker and hand over the Instructions.