Proxim AP-4000 Manuel D’Utilisation
Command Line Interface (CLI)
AP-4000 Series User Guide
Parameter Tables
211
VLAN/SSID Parameters
Other Parameters
IAPP Parameters
NOTE: These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their
default value unless a technical representative asks you to change them.
Wireless Multimedia Enhancements (WME)/Quality of Service (QoS) parameters
The Wireless Multimedia Enhancements commands enable and configure Wireless Multimedia Enhancement/Quality of
Service parameters per wireless interface. The following two commands are part of the Wireless Interface Properties
table.
Service parameters per wireless interface. The following two commands are part of the Wireless Interface Properties
table.
Name
Type
Value
Access
CLI Parameter
VLAN
Group
N/A
R
vlan
Status
Integer
enable
disable (default)
disable (default)
RW
vlanstatus
Management ID
VlanId
-1 (untagged)
or 1 - 4094
or 1 - 4094
RW
vlanmgmtid
Name
Type
Value
Access
CLI Parameter
IAPP
Group
N/A
R
iapp
IAPP Status
Integer
enable (default)
disable
disable
RW
iappstatus
Periodic Announce
Interval (seconds)
Interval (seconds)
Integer
80
120 (default)
160
200
120 (default)
160
200
RW
iappannint
Announce Response
Time
Time
Integer
2 seconds
R
iappannresp
Handover Time-out
Integer
410 ms
512 ms (default)
614 ms
717 ms
819 ms
512 ms (default)
614 ms
717 ms
819 ms
RW
iapphandtout
Max. Handover
Retransmissions
Retransmissions
Integer
1 - 4 (default 4)
RW
iapphandretx
Send Announce Request
on Startup
on Startup
Integer
enable (default)
disable
disable
RW
iappannreqstart