Pelco Endura KBD5000 Series Keyboard C1620M-B (9/05) Manuel D’Utilisation

 

C1620M-B (9/05)

9

 

3. Refer to Figure 5. Select a module. Each receptacle on the base has an attached USB cable. Turn the module upside down. Plug the USB 

connector cable into the USB port on the bottom of the module. Thread the USB connector cable through the plastic strain reliefs on the 
module to hold the cable in place.

 

Installing the Modules

 

4. Refer to Figure 5. Turn the module upright so its top faces the rear of the base. (The rear of the base is the side with the connectors.)     

Wind the cable clockwise around the base of the module, making sure to tuck any extra cable back into the hole in the receptacle. 

 

 insert the module into the receptacle. 

5. Holding the module in the receptacle, turn the base on its side. Insert the special security screw (supplied) through the bottom of the base 

and into the bottom of the corresponding module. Tighten with the special security bit (supplied).

6. Repeat steps 3 through 5 for the other two modules.

 

The KBD5000 lets you rotate each module to a position most comfortable for you. Each module can be rotated in its receptacle by pushing with 
your fingers against the raised plastic tabs on the module.

 

  Pinching the cable can result in damage.

 

  Rotating the module with a pinched cable can damage the cable.