Trilogy Touch Technology Trilogy Commander Digital Intercom 9 Manuel D’Utilisation

 

Follow the sequence below, step by step, to install the Commander matrix. 

• Unpack 

the 

matrix 

•  Fit the matrix frame and power supplies into the equipment bay 
•  Load the modules into the matrix frame, in sequence 
•  Apply power to the system and check basic operation. 
•  Connect control panels and check operation with the supplied flash ram configuration. 
•  Set up the configuration PC. 

 

Carefully unpack the equipment from its transit material and check each item for signs of 
damage.  

Check the contents of the boxes against our despatch note and your original order to ensure 
that you have received the correct parts. 

In the event that the unit has been damaged or does not match your order, immediately 
contact Trilogy Communications at the address given at the front of this guide. 

 

The Central Matrix is built in multiples of 6U. The depth (excluding mating connectors) is 
420mm. Control Panels are standard 19” rack mounting units; most panels are 2U although 
a series of 1U panel are available and custom panels may be 3U or larger. The Power 
Supply requires additional space – see Section 2.5 for further details. 

It is most likely that a system contractor or Trilogy personnel will install the central matrix. 
Suitable care should be taken with cooling and ventilation within the equipment bay. There 
are a number of internal connections between racks of multiple rack systems. Refer to the 
Technical Guide or Trilogy Communications for further details. 

 

 

 

In a multi frame system, the ports are located as 
follows: 

¾  Frame 6  Ports 481 - 576 

¾  Frame 5  Ports 385 - 480 

¾  Frame 4  Ports 289 - 384 

¾  Frame 3  Ports 193 - 288 

¾  Frame 2  Ports 97 - 192 

¾  Frame 1  Port 1 - 96