Paxton Automotive Novi 2000 Supercharger 1201810 Manuel D’Utilisation
2-1
P/N: 4809644
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
13DEC04 v2.0 03-05Viper(4809644v2
.0)
2. OIL FEED
A.
Remove the oil dipstick by removing the
retaining screw from the passenger side
valve cover.
retaining screw from the passenger side
valve cover.
B.
Drain the engine oil and remove the oil
filter.
filter.
C.
Remove the oil pan.
D.
Remove the oil pressure sender (1 1/8")
from the passenger side of the engine in
front of the engine mount.
from the passenger side of the engine in
front of the engine mount.
*** IMPORTANT ***
Use clean engine oil on the pipe threads. Teflon tape
and sealant is NOT recommended as it might loosen
and cause blockage of the small oil feed orifice result-
ing in supercharger failure.
E.
Install the 1/8" NPT TEE in the oil sender
hole. Leave the TEE pointed down.
hole. Leave the TEE pointed down.
F.
Install the appropriate 1/8" NPT x –4 fitting
into the TEE as shown in Fig. 2-a.
into the TEE as shown in Fig. 2-a.
G.
Install the oil pressure sender in the remain-
ing hole in the TEE and re-attach electrical
plug (see Fig. 2-b1 or 2-b2).
ing hole in the TEE and re-attach electrical
plug (see Fig. 2-b1 or 2-b2).
Fig. 2-b1 (2003 Viper)
Fig. 2-b2 (2004-2005 Viper )
Fig. 2-a
2003 VIPER OIL FEED
FITTING AND LOCATION
2004-2005 VIPER OIL
FEED FITTING AND
LOCATION
Section 2
OIL FEED
1/8"NPT TEE
H.
Temporarily cover one end of the oil feed
line and protect it from debris until connect-
ing it to the supercharger.
line and protect it from debris until connect-
ing it to the supercharger.
I.
Connect the open end of the oil feed line to
the -4 fitting. Use tie wraps to secure the line
and protect it from kinking, abrasion, and
high heat areas.
the -4 fitting. Use tie wraps to secure the line
and protect it from kinking, abrasion, and
high heat areas.