Transition Networks BFFG1XXX-1XX Manuel D’Utilisation
Transition
Networks
Appendix C:
Device Commands & Descriptions
Command
Descriptions
arp
Displays the arp cache.
clear counter
Clears counters on all ports or on a specific port. Usage:
clearcounter
clearcounter
[port=<portno>]
cls
Clears the screen.
exit
Exits the CLI/Telnet session.
factory defaults
Resets the Device to factory default settings—all current
configurations will be erased.
configurations will be erased.
help or ?
Help or ?:
Displays the available commands.
help <cmd >:
Displays the command usage in detail.
ifconfig port=<portno>
Used to configure port parameters. The port number for
the configured port must be specified. Valid port
numbers start at “1.”
the configured port must be specified. Valid port
numbers start at “1.”
Usage:
ifconfig port=<portno>
[adminstate=<enable|disable]
[autoneg=<enable|disable>]
[duplex=<full|half>]
[speed=<10|100|1000>]
[autoneg=<enable|disable>]
[duplex=<full|half>]
[speed=<10|100|1000>]
[portstring=<"value">(
max=64)
]
[iptraffic=<enable|disable>]
The configurable parameters are as follows:
adminstate: The port can be disabled or enabled.
autoneg:
autoneg:
Enable/disable Auto-Negotiation on this
port.
port.
duplex:
When Auto-Negotiation is disabled,
Duplex Mode of the port can be set to
full/half duplex.
Duplex Mode of the port can be set to
full/half duplex.
speed:
The port speed can be set to 10/100 Mbps
when Auto-Negotiation is disabled.
when Auto-Negotiation is disabled.
portstring:
A unique name can be assigned to each
port.
port.
iptraffic:
The IP traffic can be enabled/disabled on
each port individually.
Continued on next page
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
122