Trane TRACER SUMMIT BAS-APG001-EN Manuel D’Utilisation
Chapter 4 Installing the Tracer Summit BMTX BCU
42
BAS-APG001-EN
Mounting the back of the enclosure
The back of the enclosure is shipped with the termination board installed
inside it.
inside it.
IMPORTANT
The termination board should be shipped with the grounding screw
installed. Verify this by checking the location shown in Figure 18.
installed. Verify this by checking the location shown in Figure 18.
The enclosure door is shipped separately. If the door has already been
attached to the enclosure back, remove it.
attached to the enclosure back, remove it.
To mount the back of the enclosure:
1.
Using the enclosure back as a template, mark the location of the four
mounting holes on the mounting surface (see Figure 18).
mounting holes on the mounting surface (see Figure 18).
Figure 18. Enclosure mounting holes
Mounting holes
Termination board
grounding screw
(must be installed)
grounding screw
(must be installed)