Panasonic DMR-EZ485VK Mode D’Emploi
81
RQT9056
Troubleshooting Guide
Use the following connection to suit the antenna lead to
the unit’s RF IN terminal, and the 75
the unit’s RF IN terminal, and the 75
coaxial cable to the
antenna terminals on your TV or other equipment. Refer to the
other equipment’s operating instructions for more information.
other equipment’s operating instructions for more information.
If you connected this unit and a TV without an audio/video
cable, interference (lines or patterning) or a very poor picture
may appear on the TV. If this happens, follow the steps below
to change the video playback channel (RF output channel) to
remove the interference.
cable, interference (lines or patterning) or a very poor picture
may appear on the TV. If this happens, follow the steps below
to change the video playback channel (RF output channel) to
remove the interference.
This unit
from the antenna
(Flat) Twin lead
300
300
cable
300−75
transformer
To this unit’s RF
IN terminal
IN terminal
Other equipment (television etc.)
75−300
transformer
75
coaxial
cable
VHF or UHF
Television
If the Antenna Connector doesn’t Match
Changing RF Output Channel
TRACKING/V-LOCK
CH
to select “CH 3” or “CH 4”.
The unit’s display
Each time you press the button:
CH 3 (Default setting)
Each time you press the button:
CH 3 (Default setting)
CH 4 OFF
For connections with the audio/video cable, set the RF
output channel to “OFF”.
For connections with the audio/video cable, set the RF
output channel to “OFF”.
RF Output Channel
Press the channel up/down buttons
to select a RF Output Channel.
to select a RF Output Channel.
Ch. 3
OK
Press and hold
for more than
5 seconds.
5 seconds.
–
The RF output
channel number
displays on the
unit’s display.
displays on the
unit’s display.
OK
to fi nish.
Notes
When you set the RF output channel to “CH 3” or “CH 4”
Video from this unit can be viewed on channels 3 and 4 on
the TV. Press [VCR/TV] to switch to VCR mode and output
video from this unit (
Video from this unit can be viewed on channels 3 and 4 on
the TV. Press [VCR/TV] to switch to VCR mode and output
video from this unit (
16).
To Reset This Unit
To reset the channel information and the
clock settings
clock settings
On the main unit
CH
CH
Press and hold both buttons
for about 5 seconds.
To reset the ratings level settings
With the unit stopped
OPEN/CLOSE
to open the disc tray.
On the main unit
REC
CH
CH
SD CARD
Press and hold both buttons for
about 5 seconds.
about 5 seconds.
To restore the unit if it freezes
On the main unit
POWER
Press and hold for more than
10 seconds.
–The unit is off.
or
On the main unit
RESET
Press and hold for
more than 1 second
with a pointed object.
more than 1 second
with a pointed object.
You can reset both parental rating (
56) and
DVD-Video rating (
59).
Ref
erence
DMR-EZ48VP.indb 81
DMR-EZ48VP.indb 81
2007/12/13 20:44:27
2007/12/13 20:44:27