Toshiba MJ-1103 Manuel D’Utilisation
MJ-1103/1104
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENTS
5 - 6
5.3
Stapling/folding position adjustment in saddle unit
Perform this adjustment when the saddle control PC board was replaced or the stapling/folding position
must be changed for some reason.
Prepare 2 types of booklet samples using the main unit and use them for adjustment accordingly.
must be changed for some reason.
Prepare 2 types of booklet samples using the main unit and use them for adjustment accordingly.
(1) Create 2 types of booklet samples (1 set each) using the main unit.
(2) Measure the stapling and folding positions of the samples, and then perform adjustment accord-
ingly.
For stapling and folding, paper on the stacker of the stacker unit is moved to an exclusive mech-
anism for stapling or folding. Therefore adjustment must be performed individually for the folding
stopping position of the stacker and the stapling stopping position.
For stapling and folding, paper on the stacker of the stacker unit is moved to an exclusive mech-
anism for stapling or folding. Therefore adjustment must be performed individually for the folding
stopping position of the stacker and the stapling stopping position.
* Check the folding position at the centerfold page of the sample.
Fig. 5-6
* Check the stapling position at the centerfold page of the sample.
Fig. 5-7
Sample 1
Sample 2
Media type
Recomended paper
Recomended paper
Paper size
A4
A3
Number of sheets
5 sheets
5 sheets
Paper exit
direction
Center
fold
page
-2mm - +2mm
-2mm - +2mm
Do not include the
width of the staples
Staple
When the staples are bent
-0.5mm - +0.5mm
-0.5mm - +0.5mm
Folding line
Folding line
Staple