Texas Memory Systems RamSam-210 Manuel D’Utilisation

 

 

- 11 - 

 
The front panel menu system is as follows: 
 
 

RS-210 Main Menu 

• 

Ethernet Setup 
§ Set IP Config 

§ Static 

§ IP 
§ Subnet Mask 
§ Gateway 

§ DHCP 
§ BOOTP 
§ RARP 
§ None 
§ No Change (Exit) 

§ Restart Network 
§ Show Current Config 
§ Exit Menu 

• 

Manual Shutdown 
§ Power off System? 

• 

Exit Menu 

 

The RamSan-210 uses both a serial port and an Ethernet port to allow you to monitor and 
configure the system.  To access the system’s Ethernet port, the RamSan must be 
assigned an IP address, subnet mask, and possibly a gateway.  The IP address may be 
assigned in one of five ways: Static IP, DHCP, BOOTP, RARP, or No Ethernet. 
 
To setup the Ethernet, use the arrow buttons to cycle through the top-level menu options 
until “Ethernet Setup” is showing on the display.  Use the “

Select” button to 

choose this option and continue with the configuration.  You may now use the arrow 
buttons to scroll through the following menu options: “Set IP Config”, “Restart 
Network

”, “Show Current Config”, and “Exit Menu”.  “Restart 

Network

” will shutdown and restart the Ethernet port using the current IP assignment 

configuration.  Selecting “Show Current Config” will display a list of the current 
IP configuration, hostname, IP address, subnet mask, gateway address (if applicable), and 
hardware Ethernet address.  Use the arrow buttons to scroll up and down through the list.  
Pressing the “

Menu” button will return to the previous menu, and pressing the “Select” 

button will exit the menu system.  To continue setting up the Ethernet configuration, 
select “Set IP Config”.