Tanaka TC-355 Manuel D’Utilisation

 
 

 
www.tanakapowerequipment.com                          4                                              custsvc@tanaka-ism.com

 

 

Drain all fuel from fuel tank and pull fuel filter line from tank.  Pull filter 

element out of holder assembly.  Replace filter if it appears to be 

discolored or hardened from use.  The filter has a white, felt-like 

appearance when new.

 

 

Spark plug  
The spark plug condition is influenced by: 

• An incorrect carburetor setting. 
• Wrong fuel mixture (too much oil in the gasoline) 
• A dirty air filter. 
• Difficult  running conditions (such as cold weather). 

These factors cause deposits on the spark plug electrode, which may result in malfunction and starting difficulties. If the engine 

is low on power, difficult to start or runs poorly at idling speed, always check the spark plug first. If the spark plug is dirty, clean 

it and check the electrode gap. Readjust if necessary. The correct gap is 0.6 mm (.024”). The spark plug should be replaced 

after about 100 operation hours or earlier if the electrode is badly eroded. 

NOTE! 
In some areas, local law requires using a resistor spark plug to suppress ignition signals. If this machine was originally equipped 

with resistor spark plug, use the same type of spark plug for replacement. 

Muffler  
Remove the muffler and clean excess carbon from the exhaust port or muffler inlet every 100 hours of operation.   
If you find corrosion on the muffler, replace it. 
Cylinder (Engine cooling)  
The engine is air cooled, and air must circulate freely around engine and over cooling fins on cylinder head to prevent 

overheating. 
Every 100 Operating hours, or once a year (more often if conditions require), clean fins and external surfaces of engine of 

dust, dirt and oil deposits which can contribute to improper cooling. 
NOTE! 
Do not operate engine with engine shroud or muffler guard removed as this will cause overheating and engine damage.