TANDBERG TC3.0 Manuel D’Utilisation
D14635.02—MARCH 2010
28
TANDBERG Codec C90 and Profiles using C90
Administrator guide
Contents
Introduction
Advanced configuration
Password protection
About monitors
Audio matters
Appendices
Contact us
www.tandberg.com
Standby BootAction
Decide what the system is going to do on boot.
Valuespace: <None/Preset1/Preset2/Preset3/Preset4/Preset5/Preset6/Preset7/Preset8/
Preset9/Preset10/Preset11/Preset12/Preset13/Preset14/Preset15/RestoreCameraPosition/
DefaultCameraPosition>
Preset9/Preset10/Preset11/Preset12/Preset13/Preset14/Preset15/RestoreCameraPosition/
DefaultCameraPosition>
None: No action.
Preset 1..15: Activate the selected preset.
RestoreCameraPosition: Set the camera to the position it had before the last boot.
DefaultCameraPosition: Set the camera to the factory default position.
Preset 1..15: Activate the selected preset.
RestoreCameraPosition: Set the camera to the position it had before the last boot.
DefaultCameraPosition: Set the camera to the factory default position.
Example:
Standby
BootAction: DefaultCameraPosition
Standby Control
Determine whether the system should go into standby mode or not.
Valuespace: <On/Off>
On: Enter standby mode when the Standby Delay has timed out. Requires the Standby Delay to be set
to an appropriate value.
Off: Not entering standby mode.
to an appropriate value.
Off: Not entering standby mode.
Example:
Standby
Control: On
Standby Delay
Define how long (in minutes) the system shall be in idle mode before it goes into standby mode. Requires
the Standby Control to be enabled.
the Standby Control to be enabled.
Valuespace: <1..480>
Range: 1-480 minutes
Example:
Standby
Delay: 10
Standby StandbyAction
NEW TC2.1 Decide what the system is going to do when going into standby mode.
Valuespace: <None/PrivacyPosition>
None: No action.
PrivacyPosition: Turns the camera to a sideways position for privacy.
PrivacyPosition: Turns the camera to a sideways position for privacy.
Example:
Standby
StandbyAction: PrivacyPosition
Standby WakeupAction
Decide what the system is going to do when leaving standby mode.
Valuespace: <None/Preset1/Preset2/Preset3/Preset4/Preset5/Preset6/Preset7/Preset8/
Preset9/Preset10/Preset11/Preset12/Preset13/Preset14/Preset15/RestoreCameraPosition/
DefaultCameraPosition>
Preset9/Preset10/Preset11/Preset12/Preset13/Preset14/Preset15/RestoreCameraPosition/
DefaultCameraPosition>
None: No action.
Preset 1..15: Activate the selected preset.
RestoreCameraPosition: Set the camera to the position it had before entering standby.
DefaultCameraPosition: Set the camera to the factory default position.
Preset 1..15: Activate the selected preset.
RestoreCameraPosition: Set the camera to the position it had before entering standby.
DefaultCameraPosition: Set the camera to the factory default position.
Example:
Standby
WakeupAction: RestoreCameraPosition
The Standby settings
The Standby settings,
cont...
Contact us
Contents
Introduction
Advanced configuration
Password protection
About monitors
Audio matters
Appendices
Advanced config.