Omnia Industries Food Processor Omnia One Multicast Stero Audio Processor with SENSUS Manuel D’Utilisation

[Mono L+R] - 

Configures the DSP processing chain to have both the Left and Right internal 

channels fed from the sum of the Left Channel and Right Channels of the input source selected. 
Note that this selection is active in all sources selected as Primary and Secondary (Failover) audio 
sources. 

 

[SWAP] - 

Configures the DSP processing chain to swap the Left and Right internal channels, 

that is, the DSP Left Channel is fed from Right Channel input and the DSP Right Channel is fed 
from the Left Channel input. Note that this selection is active in all sources selected as Primary 
and Secondary (Failover) audio sources. 
 

<-Exit 

 

Click on this option to return to the Input/Output menu. 

 
 
Output 

 

There are five controls under the heading “Output” and each will be explained in the order in which they appear 
in the menu: 

 

<-Exit 

 

 

 

Click on this option to return to the Input/Output menu 

 

Anlg Level (Analog Level) 

 
 

 

Adjusts the master audio Output level for the analog outputs which appear on the rear panel XLR  

 

 

male connectors. This control adjusts both the left and right stereo channel simultaneously. 

 

Right Trim 

 

 

 

 

 

Allows a +/-3dB adjustment of the right analog audio channel gain to correct minor left/right 
balance problems in equipment following the OmniaONE. The left channel output gain is not 
affected by this control and is set using the master Analog Level control previously described. 

 

 
 

AES Level (AES/EBU Level) 

 

 

Adjusts the master audio Output level for the AES Digital Output which appears on the rear panel 

 

 

RJ-45 StudioHUB

®

 connector.  

 

Right Trim 

 

Allows a +/-3dB adjustment of the right digital audio channel gain to correct minor left/right 
balance problems in equipment following the OmniaONE. The left channel output gain is not 
affected by this control and is set using the master AES Level control previously described. 
 
 

Samp. Rate (Sample Rate) 

 

 

Configures the Output Sample Rate. Options are as follows: 

 

[48k] 

Slaves the output sample rate to the Omnia’s internal 48kHz sample clock. To use output 
sample rates other than 48 kHz, Input or External sync must be used. 

47