Omni Group Step Top Wood Stove 57ST-ACC Manuel D’Utilisation
November 28, 2011
7038-159D
Page 29
R
5700 Step Top Wood Stove Series ACC
G. Tools And Supplies Needed
H. Fire Safety
To provide reasonable fi re safety, the following should be
given serious consideration:
given serious consideration:
1. Install at least one smoke detector on each fl oor of
your home to ensure your safety. They should be
located away from the heating appliance and close
to the sleeping areas. Follow the smoke detector
manufacturer’s placement and installation instructions,
and be sure to maintain regularly.
located away from the heating appliance and close
to the sleeping areas. Follow the smoke detector
manufacturer’s placement and installation instructions,
and be sure to maintain regularly.
2.
A conveniently located Class A fire extinguisher
to contend with small fires resulting from burning
embers.
to contend with small fires resulting from burning
embers.
• Remove appliance and components from packaging and
inspect for damage.
• Doors are shipped in separate packages.
• Report to your dealer any parts damaged in shipment.
• Read all the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety and
benefi t.
during the installation to ensure maximum safety and
benefi t.
I. Inspect Appliance and Components
1.
Place the appliance in a location near the fi nal
installation area and follow the procedures below:
installation area and follow the procedures below:
2.
Open the appliance and remove all the parts and
articles packed inside the Component Pack. Inspect
all the parts and glass for shipping damage. Contact
your dealer if any irregularities are noticed.
articles packed inside the Component Pack. Inspect
all the parts and glass for shipping damage. Contact
your dealer if any irregularities are noticed.
3.
All safety warnings have been read and followed.
4.
This Owner’s Manual has been read.
5.
Floor protection requirements have been met.
6.
Venting is properly installed per venting manufactur-
ing instructions.
ing instructions.
7.
The proper clearances from the appliance and chim-
ney to combustible materials have been met.
ney to combustible materials have been met.
8.
The masonry chimney is inspected by a professional
and is clean, or the factory built metal chimney is
installed according to the manufacturer’s instruc-
tions and clearances.
and is clean, or the factory built metal chimney is
installed according to the manufacturer’s instruc-
tions and clearances.
9.
The chimney meets the required minimum height.
10.
All labels have been removed from the glass
door
door
.
11.
Plated surfaces have been wiped clean, if appli-
cable.
cable.
12.
A power outlet is available nearby if installing
optional blower assembly.
optional blower assembly.
Pre-Burn Check List
WARNING! Risk of Fire!
Inspect appliance and components for damage.
Damaged parts may impair safe operation.
Damaged parts may impair safe operation.
• Do NOT install damaged components.
• Do NOT install incomplete components.
• Do NOT install substitute components.
Report damaged parts to dealer.
Reciprocating saw
Framing material
Pliers
High temp caulking material
Hammer
Gloves
Phillips screwdrive
Framing square
Flat blade screwdriver
Electric drill and bits
Plumb line
Safety glasses
Level
Tape measure
1/2-3/4 in. length, #6 or
#8 self-drilling screws
#8 self-drilling screws
Misc screws and nails
Before beginning the installation be sure the following tools
and building supplies are available:
and building supplies are available: