Nuvo Telephone NV-USBW Manuel D’Utilisation

8

If the selection window shown in Figure 6 does not come up, but a “Confirm Configuration Parameters” 
window comes up instead at this point, the wireless PC you are using has failed to locate the Device 
Server.

(a) Double-check to make sure that the Device Server is physically located as explained in Step  (1)     

          of the  “What You Need for Setup” section.

(b) Double-check to make sure the Device Server is powered up and displaying the LED status 
explained in Step (1) of this “Wireless Network Setup” section.

If either of these steps was missed, repeat steps (1) through (9) in this section.  If you still don't see the 
selection window shown in Figure 6, contact NuVo Technical Support at (866) 796-4904 for further 
assistance.

Select the Device Server line as shown in figure 6, if it is not already selected.  Then, left-click the 
“Next” button.

(10)   Make certain that the default “Get IP Address Automatically” option is set in the “Setting 
            TCP/IP” window shown in Figure 7.  In the unlikely event that the user's network is set up 
            without Dynamic Host Control Protocol (DHCP) enabled, then you will have to click Assign IP 

                                Address, and enter the values for the three fields “grayed out” in the image below.  Refer to  
                                the Silex manuals available on the NuVo NV-USBW/SX-2000WG setup CD for details.  Then, 
                                left-click  the “Next” button.