Nuvo NV-WIPS Manuel D’Utilisation

The Wireless NuVoDock is designed to communicate with the Grand Concerto  

and Essentia E6G Systems.  Installation and setup require a few simple steps.

  Place the NuVoDock and NV-PSW12A power supply in a zone 

location. Likewise, place the NV-WIPD wireless receiver with the 

Grand Concerto EZ Port or Esssentia E6G AllPort connection hub. 

  Set the Source Input Switch to the appropriate source input 

number 1-6 on the bottom of the NV-WIPD and the back of the 

NuVoDock. This must coincide with the source input on the back of 

the NuVo amplifier. This step must be done prior to connecting the 

power supply.

 Complete the connections at the NV-WIPD wireless receiver. Plug 

the CAT5 Network connection into one of  the “Device” inputs on 

the EZ Port or AllPort, and the NV-CMR6B stereo mini to RCA audio 

cable from the audio output on the NV-WIPD wireless receiver  to 

one of the six source inputs on the back of the NuVo amplifier.

 Make sure the NuVoDock is plugged into an AC power outlet.

  Once the Wireless NuVoDock is installed and the Grand Concerto/ 

Essentia System is installed, you will be able to place an iPod in the 

NuVoDock (see the Supported iPod Models page for compatible 

iPod versions) for communication with the system Control Pads. 

The iPod display will be replaced with the NuVo logo when in 

NuVoNet communication, and return to normal iPod display when 

the iPod is removed from the NuVoDock.

* Note: When using a iPod Touch on the NuVoDock it will display “Accessory 

Attached” instead of displaying the NuVo logo. 
Each NuVoDock represents an audio source input for the NuVo system and up 

to two wireless NuVoDocks can be used in a single NuVo system. If you are 

using the I8G-E6G Configurator software for setup, select the NuVo NV-WIPS IR 

library within the Source Tab for each Wireless NuVoDock used.