Nuvo 500 Manuel D’Utilisation

~2~

~3~

1. LOCATING YOUR WINE CELLAR - Remember, it is not an appliance, it is a piece of furniture

2. AREA FOR ASSEMBLING YOUR WINE CELLAR

Choose a clear 12’ by 12’ area with a level floor and carpeting to help reduce scratching of surfaces.

3. TOOLS

* Hex wrench (included)

* Phillips screwdriver

* Carpenter’s level

* Helper or two is strongly recommended

4. TEST THE COOLING UNIT

Plug it in for a few minutes on a table top, to verify that controls and display are functional, and that

the unit is producing cool air after a few minutes of operation.

Note that the electronic controller has a one-minute cautionary delay between initial plug-in and

start-up of the compressor.

NOTE: Fill out the WARRANTY REGISTRATION FORM with the serial number located on the LEFT

SIDE of unit.

Provide 4” minimum clearance for both sides and back, keep the top completely clear.

Under no circumstances should the unit be “built-in” in any way.

Never

locate your wine cellar outdoors or in an area with extremes of temperature and

humidity.

Garages, attics, unfinished basements, laundry rooms, breezeways, closets, bedrooms or

any unventilated room. In other words these units must be installed in air-conditioned

environments which do not “trap” the warm air being exhausted.

Temperatures in surrounding area must not exceed 80 °F (25 °C) with humidity levels not

to exceed 70% R.H. (Relative Humidity). Never set your temperatures below default (57ºF)

whenever ambient conditions are warm (above 75ºF) or humid (above 50%R.H.).

Outlet power must be a DEDICATED separately fused, grounded, 15 Amp 110 - 120 V line or

7.5 Amp - 240 V line rated for your unit

(CHECK BOX OR SERIAL NUMBER LABEL ON UNIT

FOR YOUR LINE VOLTAGE REQUIREMENTS).

You must monitor your unit DAILY. If unit is in “Alarm”, unplug the unit inmediately. Always

check for any water (condensate) leaks.

Vintage Keeper will not be liable or responsible for incidental or consequential damages.

(See Warranty).

Place unit in a clean area and allow access to the exterior surfaces for periodic vacuuming

of the condensor coil. (See troubleshooting for details.)

Always remove all bottles before relocating your wine cellar.

READ BEFORE YOU START