Nextar XPJ Manuel D’Utilisation

1. Plug the power cord into the projector and into a wall socket. Turn on the wall socket switch (where fitted). 

Check that the Power indicator on our projector adapter lights orange after power has been applied. 

2. Plug the DC plug into the projector’s 12VDC socket. Remove the lens cap. If it is left on, it could become 

deformed due to the heat produced by the projection lamp. 

3. Switch on the main power at the left side of the projector. Check that the Power inductor on the projector 

lights green.   

3. Press the Power button on the remote control or projector to start the unit. The Power indicator lights off 

and lights green after 3 seconds when the unit is on. 

4. The start-up procedure takes about 5 seconds after pressing Power, and the image will appear as normal   

(If necessary). Rotate the focus ring to adjust the image clearness.

 

seconds before energizing the lamp. 

5. Switch all of the connected equipment on. 

6. You can also press Source on the projector or remote control to select your desired input signal. For more 

information, please refer to 

"Switching input signal" on page 14

. 

 

 

The projector can be connected to multiple devices at the same time; 

however, it can only display one at a time. To cycle through the available 

input sources, press the Enter button on the projector control panel, or the 

Source button on the remote control. The selected source name will display 

at the Top-Left of the screen for 10 seconds after each button press.   

mode" on page 18 

 

 

 

 

 

 

14