Nikon Universal Remote WR-1 Manuel D’Utilisation
21
Relay
Receivers can be confi gured to relay transmitter commands to an-
other receiver, increasing transmitter range and allowing signals to
be transmitted around obstacles.
other receiver, increasing transmitter range and allowing signals to
be transmitted around obstacles.
Transmitter
Relay
Receiver
1
Confi gure the relay.
On the unit that will act as the relay, slide the
Tx/Rx/OFF switch to Rx. Press the MENU button
to display the menus, then highlight SPECIAL
and press 2. Highlight RLY and press z to
confi gure the unit to act as a relay.
to display the menus, then highlight SPECIAL
and press 2. Highlight RLY and press z to
confi gure the unit to act as a relay.
2
Confi gure the remaining units.
Slide the Tx/Rx/OFF switch on one of the re-
maining units to Tx to confi gure it as a trans-
mitter, and the switch on the other unit to Rx
to confi gure it as a receiver.
maining units to Tx to confi gure it as a trans-
mitter, and the switch on the other unit to Rx
to confi gure it as a receiver.
3
Take photographs.
Position the units. When the shutter-release button on the trans-
mitter is pressed all the way down, the relay unit will pass the sig-
nal to the receiver, and the receiver will release the shutter on the
camera to which it is connected.
mitter is pressed all the way down, the relay unit will pass the sig-
nal to the receiver, and the receiver will release the shutter on the
camera to which it is connected.