Nikon Home Security System WT-4 Manuel D’Utilisation
94
PC Mode
/
C
o
n
tr
o
ll
in
g t
h
h
e Ca
me
ra
ra
Using the WT-4 with a Computer
Controlling the Camera
1
Complete the steps in “Connecting to the Computer” (pp. 90–
93).
93).
2
Start Camera Control Pro 2 on the host
computer and confirm that “PC” is
displayed in the camera control panel.
computer and confirm that “PC” is
displayed in the camera control panel.
3
Control the camera as described in the Camera Control Pro 2
manual. Any photographs taken while the camera is
connected will be recorded directly to the computer hard disk.
manual. Any photographs taken while the camera is
connected will be recorded directly to the computer hard disk.
4
Turn the WT-4 off when transfer is
complete. Wait for the POWER LED (pg.
3) to turn from green to yellow and
then go out, and then disconnect the
USB cable.
complete. Wait for the POWER LED (pg.
3) to turn from green to yellow and
then go out, and then disconnect the
USB cable.
D
Wireless Networks
More time may be required to complete operations on wireless networks.
D
Ethernet Networks: Do Not Disconnect the Ethernet Cable
Do not disconnect the Ethernet cable while the camera is on.
A
Wireless Networks: Loss of Signal During Transfer
A loss of signal may interrupt the connection while pictures are being
transferred to Camera Control Pro 2. If the POWER LED on the WT-4 is
blinking (pg. 2), turn the WT-4 off and then on again. Transfer will resume
when the connection is re-established. Do not turn the camera off.
Transfer can not be resumed once the camera has been turned off.
transferred to Camera Control Pro 2. If the POWER LED on the WT-4 is
blinking (pg. 2), turn the WT-4 off and then on again. Transfer will resume
when the connection is re-established. Do not turn the camera off.
Transfer can not be resumed once the camera has been turned off.