Nexus 21 Stereo Receiver Multi Control Manuel D’Utilisation

 

MULTI CONTROL 

 

15 

 

At power on, the instrument will perform a self test. The display 
will first show all segme
the Nexus Network ID n
 
At first power on after in

SET 

(PrESkey). This will give

e instrument a logical ID number on the 

Nexus Network.  
 
 
To initialise the instrume

re

instruments, one at the 
 
 
 
Note: Always wait for 
to be displayed,  befor

er in

SET 

(PrESkey). This will give

e instrument a logical ID number on the 

Nexus Network.  
 
 
To initialise the instrume

re

instruments, one at the 
 
 
 
Note: Always wait for 
to be displayed,  befor

nts, then the software version number and 
umber. 

stallation, you will be asked to press 

stallation, you will be asked to press 

 th

 th

nt, p ss SET on all installed digital 

nt, p ss SET on all installed digital 

time.  

time.  

  

on the next instrumen
 
 
 
The Server automatical

the first unit ID number 16, then 

17 and so on. The ord
order as the instrument
Nexus Network. 
  
The example shows that the instrument version number is 2.0 and 
the given logical ID number is 16. 
 

If two instruments by mistake have the same ID number, this can 
cause disturbance and block the information on the Nexus data 
bus. 
 
To re-initialise the instrument, press CLEAR during the power up 
sequence when version and ID numbers are displayed. 
 
The display self test is then re-started on all instruments and you 
will be asked to press KEY on each instrument as explained 
above. 
 
Note!  If you do not succeed to re-initialise, we suggest you 
disconnect all but one instrument with the same ID number, then 
repeat the above procedure. 
 

ly gives 

er in which you press SET is the same 

s will be given a logical ID number on the