KVH Industries TracVision M5 Manuel D’Utilisation

In Step 4, you prepared the mounting sites for the
switchplate and MCP. Now follow these steps to
mount them.

Switchplate

a. Drill four 5/32" (4 mm) holes in the

countersunk settings in the switchplate’s

a. Fit the switchplate assembly into the

mounting hole until it is flush with the

mounting surface.

b. Secure the support frame and switchplate

assembly to the mounting surface using four

#6 screws.

c. Snap the front cover onto the switchplate to

conceal the mounting screws and support

frame.

MCP - Velcro Mount Option

a. Clean the bottom of the MCP and the

mounting surface using a mild detergent.

b. Peel the backing from the two supplied

Velcro fabric squares and stick them to the

c. Position the two Velcro hook disks onto the

mounting surface. Drill screw holes for the

disks and secure in place with #4-24 screws.

d. Press the MCP firmly into place so that the

fabric’s loop material engages the hook disks.

MCP- Flush Mount Option

a. Make sure the flush mount bracket is

attached to the MCP. If it is not attached,

disconnect all of the cables from the MCP,

attach the bracket as explained in Step 4 on

page 6, then reconnect the cables.

b. Insert the MCP and bracket assembly into the

mounting hole and secure in place with four

Switchplate

5/32" ( 4 mm)

Mounting Hole (x4)

#6 Screw (x4)

Front Cover

Mounting Surface

Figure 30: Mounting the Switchplate

Fabric Strip (x2)

Hook Disk (x2)

#4-24 Screw (x2)

Figure 31: Velcro Mounting the MCP to a Horizontal Surface

#8 Screws and
Washers (x4)

Figure 32: Flush Mounting the MCP to a Vertical Surface

Mount the Switchplate & MCP