Kreisen 3 8 6 X / X E Manuel D’Utilisation
This command indicates to MS-DOS that you want to copy
the contents of a diskette in the A drive to a new diskette
located in the B drive.
The following message will be displayed:
The “SOURCE” diskette is the disk that you will be copying from.
The “TARGET” diskette is the one you will be copying to.
The “TARGET” diskette is the one you will be copying to.
Put your master MS-DOS diskette in the A drive, and a new,
blank diskette in the B drive.
Warning!
If you have any doubts about which diskette goes in which
drive check them carefully. Make sure that the write
protect notch on the master MS-DOS diskette is covered
protect notch on the master MS-DOS diskette is covered
with a write protect tab.
Close both drive doors. Press any key, such as the
SPACE BAR. The A
drive will
be activated, and your
computer will display:
Using MS-DOS With Your Computer
4-17