Kenmore Elite 30'' Warming Drawer - Stainless Steel Guide De Montage
1
D
A
B
F
E
C
GENERAL INFORMATION
The Warm & Serve Drawer can be used:
• As a stand alone appliance
• As a combination 27" or 30" Warm & Serve Drawer with
a 27" or 30" (76 cm) built-in oven mounted above.
IMPORTANT: The warmer drawer must be
installed on a surface that is leveled from
left to right, rear to front, and is capable
of supporting 100lbs (45 Kg).
P/N 318201823 (1004) Rev. A
Combination Warm & Serve Drawer/
27" or 30" (76 cm) Built-in Oven Installation
NOTE: A 60" (152 cm) long cable is supplied with
the Warm & Serve Drawer.
FLOOR
Warm & Serve Cutout
Warm & Serve Drawer
60" (152 cm) Cord
Minimum distance to
floor 4½" (11.4 cm)
IMPORTANT: The Warm & Serve Drawer runs off a
single phase three-wire 120 volt, 60 hertz, AC only
electrical supply with ground.
H* = 11-7/8" (30,2 cm) Min. is the
space between the bottom of the warmer drawer cutout and
the bottom of the oven cutout. This is a critical dimension
and must be provided.
J** = 3" (7.6 cm) Max. Electrical Junction Box for wall oven
must be lower than warmer drawer cutout.
Bottom
of
o
ven
cutout
CAuTION: Install two 3" (7.6 cm)
wide x 3.4" (1.9 cm) thick planks
capable of supporting 200 lbs
(90.7 Kg)
wide x 3.4" (1.9 cm) thick planks
capable of supporting 200 lbs
(90.7 Kg)
Printed in the USA
WARM & SERVE DRAWER INSTALLATION INSTRuCTIONS
INSTALLATION AND SERVICE MuST BE PERFORMED
BY A QuALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S uSE.
READ AND SAVE THESE INSTRuCTIONS FOR FuTuRE REFERENCE.
FOR YOuR SAFETY: Do not store or use gasoline or other
flammable vapors and liquids in the vicinity of this or any other appliance.
Canada
united States
Warm & Serve Drawer Dimensions
Stand Alone Installation
A. HEIGHT
B. WIDTH
C. DEPTH
27" Models
11¼" (28.6 cm)
27" (68.6 cm)
23 3/8" (59.4 cm)
30" Models
11¼" (28.6 cm)
30" (76.2 cm)
23 3/8" (59.4 cm)
D. CuTOuT
HEIGHT
E. CuTOuT
WIDTH
E. CuTOuT
DEPTH
27" Models Min. 9 7/8" (25.1 cm) 25½" (64.8 cm)
23 5/8" (60cm)
Max.
10¼" (26 cm)
25¾" (65.4 cm)
24" (61 cm)
30" Models
Min.
9 7/8" (25.1 cm) 28½" (72.4 cm)
23 5/8" (60cm)
Max.
10¼" (26 cm)
28¾" (73 cm)
24" (61 cm)
A. HEIGHT
B. WIDTH
C. DEPTH
27" Models
11¼" (28.6 cm)
27" (68.6 cm)
23 3/8" (59.4 cm)
30" Models
11¼" (28.6 cm)
30" (76.2 cm)
23 3/8" (59.4 cm)
D. CuTOuT
HEIGHT
E. CuTOuT
WIDTH
E. CuTOuT
DEPTH
G.
HEIGHT
27" Min. 9 7/8" (25.1 cm) 25½" (64.8 cm)
23 5/8" (60cm)
2" (5.1 cm)
Depends
on critical
dimension
H
Max.
10¼" (26 cm)
25¾" (65.4 cm)
24" (61 cm)
30"
Min.
9 7/8" (25.1 cm) 28½" (72.4 cm)
23 5/8" (60cm)
Max.
10¼" (26 cm)
28¾" (73 cm)
24" (61 cm)