Kanguru Solutions iNAS-100 Manuel D’Utilisation

Operation Help 

1. 

Set up your Kanguru iNAS 100: 
Select the Kanguru iNAS 100 that you want to configure, and then click on 
the Configure button. An authentication window asking you to enter the 
administrator’s password appears as shown below: 

 
 
 
 
 
 
Click on OK after entering the password. If the name and password are correct, 
the configuration window is displayed on the screen: 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

er 

our ISP.

rk 

Change the LAN IP 
address settings of 
your Disk On-line 
Server. If you are not 
familiar with these 
settings, please keep 
them unchanged. 

Setup the name, date and 
time of this Disk On-line 
Server. You can input any 
name you want except 
special characters. 

Configure the DHCP 
service to assign the 
dynamic IP addresses 
for your local 
network.  

If PPTP is used to 
connect to the 
Internet, enter the 
PPTP server IP 
Address, user name 
and password from 
the ISP or netwo
administrator 

If PPPoE is used to 
connect to the 
Internet, enter the us
name and password 
provided by y

When finished, click on “OK”  to 
confirm and exit. 

Click “Cancel” to exit and discard 
changes. 

Use a fixed IP address for 
WAN port. You will need to 
enter the IP address, subnet 
mask and the gateway IP 
address. 

Use DHCP protocol to obtain the WAN IP 
address automatically. DHCP protocol is 
commonly used in cable broadband service 
or intranet. 

Change the settings and click on OK when done to complete the configuration 
setup. 

 

1. 

After changing some settings, you may be asked to restart the Kanguru 
iNAS 100 . 

2. 

If you want to set up detailed configuration, you need to enter the 
administration web page of the Kanguru iNAS 100 via the browser. 

 

53