Kanguru Solutions iNAS-100 Manuel D’Utilisation
Chapter
2
Installing the Kanguru iNAS 100
First Time Installation
Please follow these instructions to install your Kanguru iNAS 100 if this is the first
time you are connecting your iNAS to your network.
time you are connecting your iNAS to your network.
1. Connect the provided Ethernet cable to one of the LAN ports on the iNAS
to a LAN port on your network. If you do not have a LAN port available
on your network, then you can attach the iNAS directly to your PC’s
Ethernet port.
on your network, then you can attach the iNAS directly to your PC’s
Ethernet port.
2. Connect the provided AC power cable to your iNAS, and then to an AC
wall outlet.
3. Press the red power button located at the rear of the iNAS and wait for
the system to start up.
4. When the LCD displays “DHCP Linking…” the startup is complete.
5. Pressing the Down Button (Switch B) will display the LAN IP of
5. Pressing the Down Button (Switch B) will display the LAN IP of
192.168.1.254.
6. If there are no Network IP conflictions, you should now be able to access
the iNAS in one of two ways.
a. Open an internet browser such as Internet Explorer, and go the
following URL: http://192.168.1.254
b. Open Network Neighborhood and the iNAS will appear under the
“NAS” workgroup. Note, before you can save data to the iNAS you
must complete the Quick Configuration to enable the drive.
must complete the Quick Configuration to enable the drive.
7. The iNAS should now be connected to the network and now it’s time to
configure the iNAS to your Network. If you cannot connect to your iNAS
at this time please refer to the Troubleshooting section.
at this time please refer to the Troubleshooting section.
9