Jura Capresso 65349R3 Manuel D’Utilisation

Page de 36
MACHINE IS CLEANING
. The cleaning program will dispense 
hot foamy water in intervals through the spouts. After a 
few minutes the machine beeps and the display shows 
TRAY 
GROUNDS EMPTY
.
f. Lift and remove the drawer. Empty the used coffee container 
and drawer and replace. The display shows 
COFFEE READY
.
Please note: After this cleaning process, remove the powder 
funnel insert and clean under running water and replace. 
Tip: You can run a tablet cleaning cycle at anytime even if the
machine does not prompt you. It is possible that very oily coffee
beans deposit more oils slowing down the brewing process. An
extra tablet cleaning cycle will remove the oil build up.
COFFEE READY
• Push and hold the Rotary Dial until the display shows 
FILTER
.
• Turn the dial until the display shows: 
MAINTENANCE
• Push the dial and select 
CLEAN UNIT
.
• Push the dial again. 
TRAY GROUNDS EMPTY
.
• Continue with steps a. through f. above.
29. DECALCIFYING PROCESS
The machine has an integrated decalcifying program. 
This program takes about 50 minutes.
When the display shows 
COFFEE READY DESCALE
it is time
to decalcify the machine. You can still make coffee. However, it
is highly recommended that you decalcify the machine within the
next 3 to 4 days. 
Please note: If you use the Clearyl water cartridge and the display
shows 
COFFEE READY DESCALE
then your cartridge function
is not activated. Follow the instructions in chapter 23a to 
program the Clearyl Cartridge function. If the cartridge is in use
for several weeks install a new cartridge. 
Important: The decalcifying program must not be interrupted. 
DECALCIFYING AGENT: Only use our special decalcifying 
tablets Model # 61848, see chapter 34.
CAUTION: Never use vinegar or any other decalcifying agent. 
This might damage internal parts of the machine. 
CAUTION: Immediately remove any splashes or drops of the
decalcifying solution from sensitive surfaces, such as natural
stone or wood.
Always wait until the decalcifying solution in the water tank has
been used up. Do not fill additional decalcifying solution into the
water tank.
a. Push and hold the rinse button until the display shows 
TRAY /
GROUNDS EMPTY
.
b. Remove and empty the drawer and used coffee container 
TRAY MISSING 
and replace complete assembly (Fig. 2). 
Important: Even if the drawer and the used coffee container are
empty, you still need to remove the drawer for approx. 20 seconds
and then replace it. The display shows 
SOLVENT IN TANK
.
c. Remove and empty the water tank. 
d. Dissolve 3 of the large square decalcifying tablets in a con-
tainer with 20 oz. of water (0.6 liters) and pour the solution 
into the water tank. Replace water tank.
e.
SOLVENT IN TANK PRESS BUTTON
. Remove the Dual Nozzle
System and the Dial Component (Fig. 5a, 5b) and place one 
container underneath the milk spout. Place another container 
underneath the Hot Water Spout. Each container should  have
at least an 8 oz. capacity.
f. Push the Rinse Button. 
MACHINE IS DECALCIFYING
. For 
31.