Juiceman JM300 Manuel
4
5
† 1. Food pusher (Part # JM300-01)
† 2. Feed chute (Part # JM300-02)
† 2. Feed chute (Part # JM300-02)
3. Lid locking lever
† 4. Lid (Part # JM300-03)
† 5. Stainless steel filter (Part # JM300-04)
† 6. Juice bowl (Part # JM300-05)
† 5. Stainless steel filter (Part # JM300-04)
† 6. Juice bowl (Part # JM300-05)
7. Juice spout
† 8. Juice pitcher (Part # JM300-07)
† 9. Froth separator (Part # JM300-06)
10. Base
11. Speed control
† 12. Pulp container (Part # JM300-08)
13. Pulp spout
14. Pulp opening
† 15. Cleaning brush (Part # JM300-09)
Note: † indicates consumer replaceable/removable parts
† 9. Froth separator (Part # JM300-06)
10. Base
11. Speed control
† 12. Pulp container (Part # JM300-08)
13. Pulp spout
14. Pulp opening
† 15. Cleaning brush (Part # JM300-09)
Note: † indicates consumer replaceable/removable parts
How to Use
This product is for household use only.
GETTING STARTED
• Remove all packing material and, if applicable, any stickers from the
GETTING STARTED
• Remove all packing material and, if applicable, any stickers from the
product. Remove and save literature
• Please go to www.prodprotect.com/applica to register your warranty. For
additional information and recipes for your product go to www.juiceman.
com
• Take the appliance apart following instructions in DISASSEMBLING THE
JUICE EXTRACTOR and wash all removable parts as instructed in CARE
AND CLEANING. This will remove any traces of dust or residue left from
manufacturing and shipping.
Important: Do not rinse or immerse base in water or any other liquid.
• Place base on a dry, level counter to prepare and assemble, following
• Place base on a dry, level counter to prepare and assemble, following
instructions in ASSEMBLING THE JUICE EXTRACTOR.
• Once assembled place the appliance on a level dry space, allowing air
space on all sides to provide proper ventilation for the motor.
ASSEMBLING YOUR JUICE EXTRACTOR
Important: Always make sure your juice extractor is unplugged before
Important: Always make sure your juice extractor is unplugged before
starting to assemble.
1. Place juice bowl over base with juice spout
facing towards the lid locking lever. Lower juice
bowl onto the base so that spout slides through
the oval ring on the base (B).
2. With both hands, hold the filter by the rim and
center it over drive shaft inside the juice bowl.
Carefully lower filter into the juice bowl, rotating
slightly until it drops into place; press down
firmly on the rim to secure (C).
Note: When assembled properly, the filter will
spin freely in the juice bowl. To check that it is
assembled properly, simply try spinning the filter
by the rim.
Important: The cutting blades at the bottom of the
Important: The cutting blades at the bottom of the
filter are extremely sharp! Always hold and carry
the filter by the rim.
Product may vary slightly from what is illustrated.
B
ENGLISH
C