Japan Tiger 7100e+ Manuel D’Utilisation

User Manual

145

English

Troubleshooting

This chapter describes typical problems when using the Fast
EtherNet and tips for solving them.

Problems during the self-diagnosis test and
while printing the configuration contents

Printer does not print

· Check that DIP switch [3] (Configuration report) and [4]

(Self-diagnosis test) of the Fast EtherNet are on. Turn the
printer off before changing the DIP switch.

· If the printer is on, turn the printer off and then on again.

· Ensure the printer emulation is set to “PCL” or “Automatic”.

NG is printed in the self-diagnosis test

If the ROM Check and RAM Check are NG

· Confirm that the Fast EtherNet is installed properly, then

turn the printer off and then on again.

If the EEPROM Check is NG

· Confirm that the Fast EtherNet is installed properly, then

turn the printer off and then on again.

· Turn the printer off, switch DIP switch [2] on and turn the

printer on again. This will initialize the Fast EtherNet.

If the NIC Check is NG

· Confirm that the Fast EtherNet is installed properly, then

turn the printer off and then on again.

· Confirm that the network cable is correctly connected. If

possible, connect to the network of a different segment.

A Network Format Different Than the Format of the Network
Connected is Printed

· Confirm that the network cable is installed, then turn the

printer of and then on again.

· Change the network cable, then turn the printer off and

then on again.

7100e+.p65

25/08/99, 20:55 PM

145