Jackson PRO-9776 Manuel D’Utilisation
128-7857
1 of 24
1
SELECTABLE FEATURES
The selectable features can be set manually as explained below, or with the RF feature programmer.
To set features using the RF programmer, follow the instructions packaged with the programmer.
Factory default settings are indicated by bold text.
To set features using the RF programmer, follow the instructions packaged with the programmer.
Factory default settings are indicated by bold text.
Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code.
Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
NOTE: Keyless Entry Models with no horn output will Flash the Parking Lights instead of chirp where chirp is indicated.
Also, No data will be indicated if a feature is not available for a particular model. The unit will enter the feature but no selection will be available.
Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
NOTE: Keyless Entry Models with no horn output will Flash the Parking Lights instead of chirp where chirp is indicated.
Also, No data will be indicated if a feature is not available for a particular model. The unit will enter the feature but no selection will be available.
RF Programmable Feature Bank 1 Is For Transmitter Programming See Transmitter Programming Guide.
RF Programmable Features Bank 2 Is Alarm Selectable Features:
Feature Selection
1 Chirp
2 Chirps
3 Chirps
4 Chirps
5 Chirps
6 Chirps
1st DoorL/UL
1 Sec.
3.5 Sec.
1 Sec L, Dbl. U/L
Dbl L, 1 Sec UL
Dbl L, Dbl UL
1 S l/350mS ul
2nd Accy Lock
Auto Lock On
Auto Lock Off
3rd Accy. UL
Auto UL Dr.
Auto UL All
Auto UL Off
4th Headlights
Not Available
5th Passive Locks
Passive
Active
6th Pass/Act Arm
Passive Arm
Active Arm
7th Siren/Horn
Siren/Horn
Siren Only
Horn Only
8th Horn Chirp
10mS
16mS
30mS
40mS
50mS
9th O/R Method
Custom Code
Valet
10th 2 Step U/L
On
Off
11th Chp Del Tx
On
Off
12th Volts/HdWire
Not Available
13th Trigger Circuits
Not Available
14th L/UL Poll
Not Available
15th Aux Channel 5 Select
Pulsed
Push & Hold
10 Seconds
20 Seconds
Latch On/Off
Hold 3.5 Sec For O/P
16th Aux Channel 6 Select
Pulsed
Push & Hold
10 Seconds
20 Seconds
Latch On/Off
Hold 3.5 Sec For O/P
17th Aux Channel 7 Select
Pulsed
Push & Hold
10 Seconds
20 Seconds
Latch On/Off
Hold 3.5 Sec For O/P
18th Trigger Delay
Not Available
When using the RF programmer, enter the program mode as follows:
Turn the ignition on.
Press and release valet switch 3 times;
turn ignition off then on.
Press and hold valet switch for 5 seconds.
Turn the ignition on.
Press and release valet switch 3 times;
turn ignition off then on.
Press and hold valet switch for 5 seconds.
Siren chirps 2 times indicating access to RF feature program mode.
Model PRO-9776
Installation Manual