Multiquip Webcam b46s90 Manuel D’Utilisation

Blades are a vital part of finishing concrete. This trowel, 

or finisher, has been designed to finish concrete and the 

blades are built to stringent quality standards out of the 

finest steel. 
If you need replacement blades, consult the parts list in 

this manual for part numbers and order them from your 

Multiquip parts dealer or importer.

This trowel is equipped with combination float/finish (Figure 

36) blades as original equipment. These blades have been 

designed for optimum performance in both the floating and 

finishing operations. These blades are versatile and should 

take care of most troweling needs.

These blades  (Figure 37) have been specifically designed 

for finish operations with this trowel. They will provide a 

premium surface finishing capability from your trowel. They 

should only be used after the concrete has set to the point 

where the trowel does not sink into the concrete when 

placed on it.

Trowel blades should be changed when they fail to finish 

concrete in a satisfactory manner.

These blades will clip (Figure 38) onto an existing installed 

blade, allowing your finisher to float on “wet” concrete so 

that the troweling operation can begin as early as possible. 

These blades are easily removable, so that after the floating 

operation, when the concrete is sufficiently cured, they can 

be removed to expose the finish blades for continued 

troweling.

These round discs (Figure 39) attach to the spiders and 

allow the machine to “float” on “wet” concrete. The disc 

design allows early floating and easy movement from wet 

to dry areas. They are also very effective in embedding 

large aggregates and surface hardeners.

For optimum panning performance blade speed must 

be changed. Use Low Speed Kit. Reference Engine 

Assembly in parts section of this manual.