Multiquip Sander SFCS-16 Manuel D’Utilisation

 

 

9) Couple the NEMA L5-15R receptacle of the factory 
supplied extension cord and the NEMA L5-15P plug 
located on the FLOOR COVERING SCRAPER 
together. Twist to lock. FIGURE 22. Connect the GFI 
to the power source receptacle. 
 
10) Grasp the operator handle with firm gripping. 
When starting the electric motor, apply  a down force 
directly to the operator handle to help reduce the 
amount of static machine weight against the work 
surface. The blade or ceramic tile ripper attachment 
should remain in contact with the surface.  Turn the 
ON/OFF switch to the ON position. Reduce the 
amount of applied down force on the operator handle 
as the electric motor attains its operational speed. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
FIGURE 22 
11) The FLOOR COVERING SCRAPER is not 
equipped with a centrifugal clutch assembly. The 
electric motor is directly coupled to the exciter plate. 
The exciter plate will begin to move when the electric 
motor starts. 
 
 
 

 

 

AS SOON AS THE ELECTRIC MOTOR HAS 
STARTED, THE OPERATOR MUST BE IN A 
POSITION TO ASSUME DIRECT AND FULL 
CONTROL OF THE FLOOR COVERING SCRAPER. 
FAILURE TO ASSUME DIRECT AND FULL 
CONTROL CAN RESULT IN PROPERTY DAMAGE 
AND/OR PERSONAL INJURY. 
 
12) The FLOOR COVERING SCRAPER is stopped by 
moving the ON/OFF switch located on the operator 
handle to the OFF position. For safety considerations, 
it is also recommended that the extension cord be 

disconnected from both the FLOOR COVERING 
SCRAPER  and power source receptacle whenever 
the FLOOR COVERING SCRAPER is not in use on 
the job site. 
 
 

 

 

IF THE FLOOR COVERING SCRAPER IS 
EQUIPPED WITH A TOGGLE TYPE ON/OFF 
SWITCH THE MOTOR CAN RESTART IF THE 
ON/OFF SWITCH IS NOT MOVED TO THE OFF 
POSITION WHEN THE POWER SOURCE LOOSES 
POWER AND THEN BECOMES RE-ENERGIZED. 
 
13) If the FLOOR COVERING SCRAPER is equipped 
with  a  magnetic start (push button) type ON/OFF 
switch, the motor will not restart if the power source 
looses power and then becomes re-energized unless 
the OFF button is first pushed.  
 

 

 

If the FLOOR COVERING SCRAPER and/or an 
individual component/accessory does not appear 
to be functioning properly, STOP and do not 
further operate the FLOOR COVERING SCRAPER 
until the proper corrective action has been 
completed. If there are any questions regarding 
the proper operation of the FLOOR COVERING 
SCRAPER, contact the Customer Service 
Department BEFORE further utilization. There is 
no charge for this service. 
 
 
 
OPERATING THE FLOOR COVERING SCRAPER 
ON THE JOBSITE. 

 

 

PERSONNEL.