Multiquip Marine Lighting GB114BS/BP Manuel D’Utilisation

REMOVING THE LAMP ASSEMBLY

Allow lamp (Figure 17) 15-20 minutes to cool before 

1. 

changing.

Hot Lamp Surface

If lamp assembly is attached to offset pole, loosen 

2. 

T-handle knob (Figure 18) that secures the lamp to the 
offset pole.

T-Handle Knob

Lift lamp assebly from offset pole, and place on a 

3. 

suitable work bench that is free of dirt, and sharp 
objects that could damage the balloon.

Before performing any maintenance 
procedures, be sure to READ the lamp, 
balloon, and general safety guidelines 
in this manual. Failure to read and 
understand these safety guidelines could 
cause severe equipment damage and 
bodily harm. 

T-HANDLE

KNOB

LAMP

ASSEMBLY

REMOVING THE BALLOON

Expose the balloon (Figure 19) by pulling down on the 

1. 

velcro tabs and unzip the protective cover as shown in 
Figure 7. Next, fold the protective cover into itself and 
zip

Exposing the Balloon

Unzip the zipper (Figure 19) at the bottom of the balloon 

2. 

and roll  the balloon envelope upwards to expose the 
lamp (Figure 20). Remove the lamp guard to gain 
access to the lamp. DO NOT use excessive force when 
unzipping the balloon.

Removing the Lamp Guard

DO NOT use excessive force when zipping 
or unzipping the balloon. The possibility 
exists of the zipper tearing, which would 
make the balloon unusable.

BALLOON

PROTECTIVE

COVER

(FOLDED)

ZIPPER

(BOTTOM)

ZIPPER

(TOP)

DO NOT USE

EXCESSIVE FORCE

WHEN ZIPPING OR

UN ZIPPING THE

BALLOON

TO REMOVE

LIFT UPWARDS

FROM PIPE FRAME

LAMP GUARD

PIPE FRAME

BALLOON

LAMP GUARD