MTD TLP 2824-Z Manuel D’Utilisation

Feed Button Modes

980533-001 A

TLP 2824-Z User Guide

55

With the printer power off, press and hold the feed button while you turn on the power.  The printer prints out a listing of 
its current configuration.  After printing the label, the printer will automatically enter a diagnostic mode in which the 
printer prints out a literal representation of all data subsequently received.  To exit the diagnostic mode and resume 
printing, turn off and then turn on the printer.

With the printer power on and top cover closed, press and hold the feed button for several seconds.  The green status 
LED will flash a number of times in sequence.  The explanation at the right (Action) shows what happens when you 
release the key after the specific number of flashes

A configuration label prints.

The media sensor calibrates and a media sensor profile prints (see “Manual Calibration” 
earlier in this chapter).

To reset the communication parameters. Press and release the feed button while the LED 
rapidly flashes amber and green.  

For autobaud synchronization: Send a ZPL II format to the printer while the LED rapidly 
flashes amber and green. When the printer and host are synchronized, the LED changes to 
solid green. NOTE: No labels will print during autobaud synchronization.

Resets the factory defaults, auto calibrates, and saves settings into memory.

The print width calibrates. While the status LED alternately flashes green and amber, a 
series of stacking rectangles print on the label. When the rectangle prints to the outer 
edges of the label, press and release the feed button. The label width and current 
communication parameters will be saved into memory.

The print darkness calibrates. A series of nine samples print, starting with the lightest and 
ending with the darkest image. When the desired print darkness is achieved, press and 
release the feed button. The print darkness will be saved into memory