Motion Computing M1400 Manuel D’Utilisation

Chapter 4  Using Your Motion Tablet PC

Motion Computing M1400 Tablet PC User Guide 58

7. When the Capture Fingerprint window 

appears, press your finger against the 
swipe sensor. Start the scan with the 
finger’s knuckle over the top of the 
gold-colored finger-drive ring (1). 
Slowly swipe the finger down over the 
sensor (2). Be sure your finger touches 
both the gold finger-drive ring and the 
sensor surface during the scan. If the 
capture is successful, you will see a 
green fingerprint in the capture area. 

If the capture is unsuccessful, a green 
fingerprint will not appear in the scan 
area. Swipe your finger across the 
sensor again.

8. After the first scan is successful, 

OmniPass prompts you to scan your 
fingerprint two more times. Wait until 
the green fingerprint disappears from the display and the fingerprint 
area is empty before swiping our finger again.

HINTS FOR SUCCESSFUL FINGERPRINT CAPTURES 
• When scanning, press hard enough to fully contact both the drive ring and the 

sensor.

• Rub your fingers together to stimulate the natural skin oils so your fingerprint 

is easier for the sensor to detect.

• Clean the sensor. First, power down the Tablet PC and remove the battery. 

Then, clean the sensor using a cotton swab sprayed with a window-type 
cleaner (no bleach, solvents, or abrasives); then dry the sensor. Do not spray, 
pour, or otherwise dispense any liquid directly on the sensor.

NOTE: If the fingerprint capture times out, tap 
Back. This restarts the enrollment process.